New: a free one-page cheat sheet for your camera. Get yours by email
Guide

180 Degree Shutter Rule: Shutter Speed for Video Explained

The 180 degree shutter rule in plain English: what shutter speed to use for 24p, 30p and 60p video, when to break it, and how ND filters help outdoors.

This guide contains affiliate links. If you buy through them, theCamera.School may earn a commission at no extra cost to you.

A young videographer stands on a sunny city sidewalk in late-afternoon light, holding a small unbranded cinema camera with a dark filter on the lens while a friend walks past in soft motion blur.

The short version

  • For natural-looking video, set your shutter speed to about double your frame rate: 1/50 at 24p, 1/60 at 30p and 1/125 at 60p.
  • A 180 degree shutter angle means the shutter is open for half of each frame's time, so 180 degrees gives the same natural look at any frame rate.
  • Sony's FX3 help guide explains that a fast shutter catches the instant of movement and a slow shutter turns it into a trailing image, which is why shutter speed changes how motion feels.
  • The Sony FX3 has no built-in ND filters, so outdoors you add an ND filter to the lens to keep your shutter at 180 degrees in bright sun.
  • On the FX3 with firmware Ver. 6.00 or later, you can choose shutter speed or shutter angle under MENU → Exposure/Color → Exposure → Shutter Mode.
  • Sony stores the Speed and Angle settings separately, so after switching between them, check your exposure again.

The 180 degree shutter rule says your shutter speed for video should be about double your frame rate: 1/50 at 24p, 1/60 at 30p and 1/125 at 60p. That setting gives moving things a small, soft blur, and that blur is what makes video look smooth and natural instead of choppy or smeared.

What the 180 degree shutter rule means

Video is a stack of still pictures played back very fast. Frame rate is how many of those pictures your camera takes every second. So 24p means 24 pictures every second, and 60p means 60.

Shutter speed is how long each of those pictures lets light in. Think of the shutter as a door. At 1/50, the door opens for one fiftieth of a second, then shuts.

The rule is simple: keep the door open for about half the time each frame gets. At 24p, each frame gets 1/24 of a second. Half of that is 1/48. Most cameras don't offer 1/48, so you pick the closest choice, which is 1/50. That's it. Close is good enough.

Where the name "180 degrees" comes from

Picture a pie. A whole pie is 360 degrees. Half a pie is 180 degrees.

Shutter angle is a way of saying how big a slice of each frame's time the shutter stays open. 180 degrees means half. 90 degrees means a quarter, so the door is open for less time and motion looks crisper. 360 degrees means the door is open the whole time, so motion looks blurrier.

Here is the nice part about angles. 180 degrees always means "half," no matter which frame rate you choose. If you switch from 24p to 60p, 180 degrees still gives you the natural look, and you don't have to redo the math.

Shutter speed for video: the cheat sheet

Find your frame rate on the left, then set the shutter speed next to it.

Frame rateExact halfShutter speed to pickShutter angle
24p1/481/50180°
25p1/501/50180°
30p1/601/60180°
50p1/1001/100180°
60p1/1201/125180°
120p1/2401/250180°

Think of this as a rule of thumb, not a law. If your camera's nearest choice is a little faster or slower, use it and keep shooting.

Why the 180 degree rule looks natural

Wave your hand in front of your face. You don't see a perfectly sharp hand. You see a soft smear. That little smear is what makes motion feel real to your eyes.

Sony's FX3 help guide describes the same idea: a fast shutter catches the instant of the movement, and a slow shutter shows the movement as a trailing image. In video, every frame carries a bit of that trail, and the trails link one frame to the next.

If the shutter is much too fast, like 1/1000 at 24p, each frame is frozen sharp. Motion jumps from frame to frame, a bit like a flip book with pages missing.

If the shutter is much too slow, like 1/25 at 24p, each frame is smeared. Things look dreamy or messy.

Half-open sits in the middle. Not too sharp, not too soft. Just right.

When to break the rule

Rules are a starting point. Once you know what the rule does, you can step away from it on purpose. If you have broken it by accident before, that's fine. Now you know how to make that look whenever you want it.

Fast action you want to feel sharp and intense

A faster shutter, like 1/250 or 1/500 at 24p, makes each frame crisper and motion more jittery. Some fight scenes and sports clips use this look on purpose. Try it when you want energy and tension.

Slow motion

For slow motion, set your shutter for the frame rate you record at, not the speed it will play back at. If you record at 120p, use about 1/250. Canon's camera museum page lists 120p HD video on the EOS 5D Mark IV and calls it ideal for slow motion.

Very dark places

A slower shutter lets in more light, but moving things blur more, and any camera shake shows up too. Sony's FX3 help guide recommends a tripod when you select a slow shutter speed. Before you slow the shutter, try opening your aperture (making the lens's pupil bigger) or raising your ISO (turning up the camera's sensitivity). Our exposure triangle guide shows how those three settings work together.

Pulling still photos out of video

Some cameras let you grab a frame from video and save it as a photo. Canon's camera museum page says the EOS 5D Mark IV can extract selected frames from 4K video as approximately 8.8 megapixel JPEG stills. If you plan to do this, a faster shutter gives you sharper frames to choose from, even though the video itself will look a little less smooth.

Using ND filters to keep the rule outdoors

Here is the problem you will run into on a sunny day. You set your shutter to 1/50. You open your aperture wide so the background goes soft and blurry. You turn your ISO all the way down. And the picture is still too bright.

On the FX3, Sony's spec sheet lists movie ISO starting at ISO 80 equivalent. Once you hit the bottom of the ISO range, only two easy moves are left: close the aperture, which loses your blurry background, or speed up the shutter, which loses your natural motion.

An ND filter fixes this. ND stands for neutral density. It is sunglasses for your lens. It makes everything darker so you can keep the shutter and aperture where you want them.

Some cinema cameras have ND filters built in, but the FX3 does not. PetaPixel reports that the FX3 was too small for built-in neutral density filters, a tradeoff Sony made to keep the camera small. CineD's review also lists no internal ND on the FX3. On cameras like this, you screw a filter onto the front of your lens.

A simple order to follow outside:

  1. Pick your frame rate.
  2. Set your shutter speed from the cheat sheet above.
  3. Set your aperture for the look you want, wide for a blurry background.
  4. Set your ISO to its lowest normal setting.
  5. Add ND until the picture looks right.

A variable ND lets you twist a ring to make the filter darker or lighter, like a dimmer switch. A fixed ND has one strength, so you might carry two or three. Either way works. When the sun goes down, take the filter off so you aren't fighting for light.

How to set shutter speed or shutter angle on Sony

I shoot on a Sony FX3, so let's start with Sony's own instructions for it.

Sony's FX3 help guide says that when shooting movies, you can choose shutter speed or shutter angle as the way the camera shows exposure time. This works when the camera's firmware is Ver. 6.00 or later. The menu path is MENU → Exposure/Color → Exposure → Shutter Mode, then pick the setting you want. The guide says this applies when Exposure Ctrl Type is set to Flexible Exp. Mode and shutter speed is set to Manual.

This option was not always there. When the FX3 launched, PetaPixel reported that Sony did not allow shutter speed to be adjusted as shutter angle. Sony's help guide now ties the feature to firmware Ver. 6.00 or later. If you don't see Shutter Mode in your menu, check which firmware your camera is running.

For normal movies, the help guide lists shutter angles starting at 5.6°. When the recording frame rate is 119.88p or 100p, the range is 5.6° to 360°. The guide also says the shutter angle is not affected by the Exposure step setting and stays constant.

One thing to watch for: the camera stores Speed and Angle settings separately, so your exposure will not match after you switch between them, and Sony says to reset your settings to get proper exposure. If your picture suddenly looks brighter or darker after switching, that's the reason. Nothing is broken.

The Sony ILME-FX30 help guide describes the same choice between shutter speed and shutter angle for movies. On that camera it needs firmware Ver. 5.00 or later, and the menu path is the same.

Shutter Priority on the FX3

To use Shutter Priority, press the MODE button, choose Shutter Priority, and press the center of the control wheel. If the camera can't reach proper exposure, the aperture value on the screen blinks, and Sony's guide says to change the shutter speed. When Shutter Mode is set to Angle, the movie shutter speed is shown in shutter angles.

In Shutter Priority, the camera picks the aperture for you, so your background blur can change in the middle of a shot. For the most control, use full manual and set all three yourself.

PetaPixel lists the FX3's launch price as $3,899.99. Prices change, so check the current price before you buy.

Setting it on Canon, Nikon and Fujifilm

The research for this guide covers Sony's menus in detail. For Canon, Nikon and Fujifilm, the idea is exactly the same, only the menu names change. Your camera's manual is the best map.

  1. Switch your camera to video or movie mode.
  2. Choose manual exposure for movies, so the camera stops picking the shutter for you.
  3. Set your frame rate first.
  4. Set your shutter speed from the cheat sheet.
  5. Look in your manual for a shutter angle option. If your camera has one, set it to 180° and it will stay right when you change frame rates.

If you are new to Canon menus, our Canon settings guide for beginners is a gentle place to start. If you haven't picked a brand yet, see Canon vs Sony vs Nikon vs Fujifilm.

Example: the Canon EOS 5D Mark IV

Canon's camera museum page lists 4K video at 30p, Full HD at 60p and HD at 120p for the EOS 5D Mark IV. Using the rule, that means 1/60 for 4K 30p, 1/125 for Full HD 60p, and about 1/250 for 120p.

Small mistakes that are easy to fix

Everybody makes these. Each one teaches you something about how your camera thinks.

  • Fixing brightness with the shutter. If your video is too bright, reach for an ND filter, a smaller aperture or a lower ISO before you change the shutter.
  • Changing frame rate and forgetting the shutter. If you move from 24p to 60p, move your shutter from 1/50 to 1/125 too.
  • Switching between Speed and Angle mid-shoot. On Sony cinema cameras the two settings are stored separately, so check your exposure after you switch.
  • Leaving video in auto. Auto picks a shutter for you, and it may not be the one that looks natural. Manual puts you in charge.

Make it a habit

I've done paid photo and video work since 2008, and the 180 degree rule is one of the simplest settings to learn. Set the frame rate, double it for the shutter, add ND when the sun is bright, and break the rule only when you have a reason.

If you shoot on an FX3 or FX30, the theCamera.School store has a $29 settings pack for those cameras.

Questions

What shutter speed should I use for 24fps video?

Use 1/50 of a second. The exact half of 1/24 is 1/48, but most cameras do not offer 1/48 as a choice, so 1/50 is the closest setting. It gives moving things a soft, natural blur.

Does the 180 degree shutter rule apply to slow motion?

Yes, but set your shutter for the frame rate you record at, not the speed it plays back at. If you record at 120p, use about 1/250. Canon's camera museum page lists 120p HD video on the EOS 5D Mark IV as ideal for slow motion, so that is the frame rate you would match there.

Can the Sony FX3 use shutter angle?

Yes. Sony's FX3 help guide says you can choose shutter speed or shutter angle for movies. You need firmware Ver. 6.00 or later, and the setting is under MENU → Exposure/Color → Exposure → Shutter Mode.

Do I need an ND filter for video outdoors?

Usually, yes, if you want to keep your shutter at 180 degrees and your aperture wide open in bright sun. An ND filter works like sunglasses for your lens. The Sony FX3 does not have built-in ND filters, so you would add one to the front of the lens.

What are good Sony FX30 shutter speed settings?

Follow the same rule: 1/50 at 24p, 1/60 at 30p, 1/125 at 60p. Sony's ILME-FX30 help guide says you can also set shutter angle instead of shutter speed for movies. That option needs firmware Ver. 5.00 or later.

How we researched this

On Nov 16, 2026 we checked the 33 factual statements in this guide (specs, numbers and comparisons) against the sources below. 26 were confirmed. 7 could not be confirmed from these sources yet.

  1. ILME-FX3 | Help Guide | Specifications · helpguide.sony.net
  2. ILME-FX3 | Help Guide | Shutter Mode · helpguide.sony.net
  3. EOS 5D Mark IV - Canon Camera Museum · global.canon
  4. ILME-FX3 | Help Guide | Shutter Priority · helpguide.sony.net
  5. ILME-FX30 | Help Guide | Shutter Mode · helpguide.sony.net
  6. Sony FX3 Review and Mini Documentary Sample Footage | CineD · cined.com
  7. Sony Reveals the FX3, an A7S III in a Compact Cinema-Focused Body | PetaPixel · petapixel.com
Jeff Fried
Jeff Fried

Photographer and video producer since 2008, with editorial work for Forbes and the Tribeca Film Festival and brand work for Disney, Apple Pay and Burton. He has shot every Canon 5D, Hasselblad and Phase One medium format, and works on a Sony FX3 today. In Denver he runs the content for UFC lightweight Drew Dober and for Easton Online, a consultancy for gym owners. More about Jeff